IEC190I   ddname, DCB RESIDES ABOVE 16MB
Start of changejn,sn,ddnameEnd of change INVALID DCBE: reason

Explanation

Start of change

This message number is for two unrelated messages.

For ddname, DCB RESIDES ABOVE 16MB:
An OPEN macro was issued with the MODE=31 parameter for one of the following:
  • a DCB that resides above 16 megabytes, or
  • an ACB, for an access method other than VSAM and VTAM®, that resides above 16 megabytes.
If ddname is ‘XXXXXXXX,’ data management could not determine the actual ddname of the DCB or ACB.
ddname
Is the DD name.
For jn,sn,ddname INVALID DCBE: reason
jn
Is the job name.
sn
Is the step name.
ddname
Is the DD name.
reason
Is the reason the DCBE is invalid:
  • EXCP DCB WITHOUT FOUNDATION EXT
  • DSORG IS NOT PS, PO OR DA
  • STORAGE NOT ADDRESSABLE
  • DCBE ID IS NOT ‘DCBE’
  • NOT MINIMUM REQUIRED LENGTH
  • DCBHIARC FLAGS ON BUT NO DCBE PTR
  • Start of changeNOT IN CALLERS KEYEnd of change
End of change

System action

For ddname, DCB RESIDES ABOVE 16MB: data management continues processing the job step; however, the data set represented by DCB or ACB does not open, and any attempts to read from or write to that data set will fail.

For jn,sn,ddname INVALID DCBE: reason, data management open processing continues but without DCBE processing for the displayed reason.

Programmer response

For ddname, DCB RESIDES ABOVE 16MB: before issuing the OPEN call, change the residency of the DCB or ACB to below 16 megabytes.

Start of changeFor jn,sn,ddname INVALID DCBE: reason, make the required changes to the DCBE, for the displayed reason.End of change

Source

DFSMSdfp

Module

IGC0001I

Routing code

11

Descriptor code

6

Parent topic: IEC messages