IEC514D DCK OR LBL ERR, dev,ser,jjj,sss [,dsname]
Explanation
- During tape volume verification, a data check occurred in open or end of volume (EOV) processing.
- The wrong volume (label type or volume serial number) was mounted.
In both cases the mount request is for a specific labeled tape volume. When the error is for a label, two specific mount requests have previously been issued for the volume specified by ser.
- dev
- The device number of the specified device.
- ser
- The volume serial number.
- jjj
- The job requesting the volume.
- sss
- The job step requesting the volume.
- dsname
- Appears when a MONITOR DSNAME command is active to indicate the data set requesting the volume.
System action
The job step waits for the operator to reply or until the task reaches the maximum time limit.
Operator response
Reply M for open or EOV processing to continue to process the mounted volume. If another data check or label error is detected, this may result in a volume demount followed by another MOUNT request for the volume specified by ser.
Reply A to abend the task, abend X'413' with a return code of X'OC' for OPEN processing, abend X'637' with a return code of X'34' for EOV processing. The abend option provides an alternative to cancelling the job when the specific labeled tape mount request cannot be satisfied.
Source
Data Facility Product (DFP)