IEC513D I/O ERR,dev,ser, labtyp,jjj,sss [,dsname]
Explanation
I/O ERR indicates that an I/O error occurred writing the labels specified, on a tape volume specified on the unit. REPLY ‘U’-ABEND OR ‘M’-MOUNT SCRATCH
- dev
- The device number of the specified device.
- ser
- The volume serial number.
- labtyp
- The label type of the mounted volume (either SL, NL, AL, or NSL).
- sss
- The step name.
- jjj
- The job name.
- dsname
- If a MONITOR DSNAME command is active, indicates the data set requesting the volume.
System action
The job step waits for the operator to reply U or M or until the task reaches time-out.
Operator response
The operator must determine if a new volume may be substituted for the one specified by ser in the message. If so, REPLY xx,‘M’ to dismount the tape and issue a mount message for a new volume to be labeled the same as the first. If a new volume may not be substituted or if private tapes were supplied to run the job REPLY xx‘U’ to ABEND the job with a message indicating that an I/O ERROR occurred. Note: A reply of M will result in creating two tapes with the same volume serial number.
System programmer response
If the error recurs and the program is not in error, look at the messages in the job log for more information. Search problem reporting data bases for a fix for the problem. If no fix exists, contact the IBM® Support Center. Provide the JCL, the SYSOUT output, the program listing for the job, and all printed output and output data sets related to the problem.
Source
DFSMSdfp
Module
IFG0194A
Routing code
1,10
Descriptor code
2