IEC208I 014-rc,mod,jjj,sss, ddname,dev,ser,dsname(member)
Explanation
The error occurred during the processing of a CLOSE macro instruction for a data set on a direct access device.
In
the message text:
- rc
- Associates this message with system completion code 014 and with the return code.
- jjj
- The job name.
- sss
- The step name.
- ddname
- DDname
- dev
- The device number.
- ser
- The volume serial number.
- mod
- The name of the module in which the error occurred.
- dsname(member)
- The data set name. Member name if specified.
The explanation for the hex return code is as
follows:
- Return Code
- Explanation
- 04
- The task which issued the CLOSE is not the task which opened the data set.
System action
The task is ended unless the error is to be ignored as specified in the DCB ABEND exit routine.
Operator response
Start a generalized trace facility (GTF) trace,
and re-create the problem. Reply to message AHL100A with:
TRACE=SYS,USR,SLIP
On
the DD statement for the data set in error, specify:
DCB=DIAGNS=TRACE
System programmer response
If the error recurs and the program is not in error, look at the messages in the job log for more information. Search problem reporting data bases for a fix for the problem. If no fix exists, contact the IBM® Support Center. Provide all printed output and output data sets related to the problem and the source program listing for the job.
Programmer response
Probable user error. Correct the errors causing the abnormal end as indicated by the return code in the message text. Rerun the job.
Source
DFSMSdfp
Module
IGG0203A