Routing

This information explains the steps that are required to configure your TCP/IP stack for dynamic, static, or policy-based routing, and explains how to verify the configuration. If you understand your entire network configuration, after you read this information you can do the following tasks:

Configure dynamic, static, or policy-based routing
Use the Ping command to ping a remote host by IP address
Use the Traceroute command to determine the path that will be taken to reach a particular destination using static or dynamic routing
Use the Netstat command to display a TCP/IP stack's routing information
Use DISPLAY commands to display dynamic routing information

Guideline: The definition or modification of an installation's routing configuration should not be performed without a complete understanding of the entire network design.