You can modify your threshold value and restart or refresh
the resolver.
Procedure
Perform the following steps to modify the UNRESPONSIVETHRESHOLD
value.
- Specify the UNRESPONSIVETHRESHOLD value that you want to
use in the resolver setup file:
- Perform one of the following steps:
- If the resolver is not active, start the resolver.
- If the resolver is currently active, issue the MODIFY RESOLVER,REFRESH,SETUP=setup_file_name command to cause the resolver
to use the new threshold setting.
If you did not specify the AUTOQUIESCE
operand on the UNRESPONSIVETHRESHOLD statement, the new percentage value is used at the end of the next sliding
5-minute interval to determine name server responsiveness.
If you specified the AUTOQUIESCE operand on the UNRESPONSIVETHRESHOLD
statement, the new percentage value is used
at the end of the next 30-second interval to determine name server
responsiveness.
Results
You know you are done when the correct UNRESPONSIVETHRESHOLD
value and AUTOQUIESCE values are displayed after you issue the START
command or the correct values are displayed in the MODIFY RESOLVER,REFRESH
command output.