Installing TCP/IP IPCS subcommands by using the panel interface
To use the panel interface to the TCP/IP IPCS subcommands,
you can either display the panels using an IPCS command or connect
the TCP/IP ISPF panels to an existing ISPF panel. No additional
installation steps are required to display the panels using an IPCS
command. To connect the TCP/IP ISPF panels to an existing panel,
find an existing panel where you wish to add TCP/IP as an option and
modify the panel. Modify the panel by adding the TCP/IP option, which
processes the following command:
PGM(BLSGSCMD) PARM(%EZBTCPEX) NEWAPPL(EZBD)
where BLSGSCMD is the IPCS command, EZBTCPEX is the TCP/IP REXX exec, and EZBD is the TCP/IP
key list prefix.You can also start the TCPIP panel interface
by performing the following steps:
- Log on to TSO.
- Access IPCS to display the IPCS Primary Option menu. Figure 1 shows an example of an IPCS Primary Option Menu.
- Select option 2, "ANALYSIS - Analyze dump contents".
- Select option 6, "COMPONENT - MVS™ component data".
- Scroll down to "TCPIP TCP/IP Dump Analysis" and select it.