The rules for splitting and swapping screens when you have combinations
of both 3270 and GUI screens are as follows:
- If you have only one 3270 screen and enter split,
the new logical screen is displayed in GUI mode.
- If you have two or more 3270 screens and enter split from
one of them, the next 3270 screen is displayed full-screen, but no
new screen is started.
- If you enter split from a GUI screen,
a new GUI screen is started (until the maximum number is reached).
- If you enter split new from either a
GUI or 3270 screen, the new logical screen is displayed in GUI mode.
- If you have one 3270 screen and one GUI screen, then entering swap from
either of these screens causes a swap to the other.
- If you have two GUI screens and one 3270 screen, swap from
one of the GUI screens swaps you to the other GUI screen. Swap from
the 3270 screen does nothing.
- If you have one GUI screen and two 3270 screens, swap from
one of the 3270 screens swaps to the other 3270 screen. Swap from
the GUI screen does nothing.
- If you have two GUI screens and two 3270 screens, swap from
one of the GUI screens swaps you to the other GUI screen. Swap from
one of the 3270 screens swaps you to the other 3270 screen.
- If you have more than two GUI screens and enter swap from
one of them, the SWAP LIST panel appears.
- If you have more than two 3270 screens and swap from
one of them, you swap to the next 3270 screen.
- Entering SWAP PREV|NEXT|screen_name|n commands in either
GUI or 3270 mode swaps as described in The SWAP command.
- After a GUI screen is enabled, you can swap to other GUI screens
using your mouse pointer.