Postprocessor output data sets
Figure 1. Postprocessor - Output Data Sets
RMF - Postprocessor Output
Command ===>
Overview record data set:
DD-Name Data Set Name
===> PPOVWREC ===> __________________________________
Report and message data sets:
===> ________ ===> __________________________________
===> ________ ===> __________________________________
===> ________ ===> __________________________________
===> ________ ===> __________________________________
===> ________ ===> __________________________________
===> ________ ===> __________________________________
===> ________ ===> __________________________________
Complete this panel and press ENTER to continue.
To return to previous panel, press END.
To return to the Postprocessor Setup Menu, enter CANCEL.
This panel allows you to specify output data sets.
The definition of the ddname PPOVWREC is mandatory if you request Overview records for further processing.
In addition, you can allocate existing data sets to the various report and message files that are created by the Postprocessor. For details about output data set allocation, please refer to Defining output data sets.
Example: Please assume that the Postprocessor
is requested to create one Overview and one Summary report, and also
Overview records, then you can route this output to your own existing
data sets userid.OVERVIEW.RECORD, userid.OVERVIEW.LIST, and userid.SUMMARY.LIST
by specifying:
===> PPOVWREC ===> overview.record
===> PPORP001 ===> overview.list
===> PPSUM001 ===> summary.list
If you want
in addition, that all interval reports should be combined into data
set userid.REPORTS.LIST, than you can specify:
===> PPRPTS ===> reports.list