GO mode - You start this by command or option
GO mode is available only when reporting on current data in the sysplex. It is not possible with preallocated data sets. Use it to monitor your system continuously. By specifying a Refresh value in the session options, you define the frequency at which the requested report will be updated. Ideally, this interval should be the same as the gathering interval defined in the MINTIME gatherer option.
Note: We recommend a separate service class for TSO users who run
permanently or frequently in GO mode, to avoid falsifying the average
TSO response time. When you run the Monitor III Reporter in GO mode,
each display of the updated report is considered as a TSO transaction.
If the range is, for example, 100 seconds, the response time for each
of these transactions is counted as 100 seconds. This has a significant
impact on the overall TSO response-time report, especially on systems
with a small number of TSO users.
For more information on STOP and GO modes, refer to Setting GO mode.