FFXX (HPR sense data)
Category and modifier (in hexadecimal):
- FF00
- HPR routing failed or not required. Bytes 2 and 3 following the sense code contain sense-code-specific information.
- 0001
- HPR routing not required.
- 0002
- HPR routing failed.
- FF10
- Values not defined.
- 0001
- Route values not defined.
- FF20
- Problem with connection setup signal.
- 0001
- Connection setup signal not present.
- FF30
- Route setup record not found or has an error.
- 0001
- Route setup record not found.
- 0002
- Route setup record found, but has an error.
- FF50
- ADJCP not found.
- 0001
- ADJCP not found.
- 0002
- Survivable CV46 error set when CPNAME in CV46 is the same as CPNAME in CV44.
- 0003
- VRBLK not found.
- FF60
- DLC NCB not found.
- 0001
- DLC NCB not found.
- 0002
- DLC NCB was found, but the reuse count was wrong.
- FF70
- RTP ALS not found or address failed.
- 0001
- RTP ALS not found.
- 0002
- RTP ALS network address in use.
- 0003
- RTP ALS CIDCTL ADD HOSTNODE failed.
- 0004
- RTP ALS state change in progress.
- 0005
- RTP ALS CIDCTL ADD NEXTNODE failed.
- 0006
- RDTADD new address failed.
- 0007
- Our NCE Instance Identifier has changed.
- 0008
- SLOCATE failed.
- 0009
- During Route_Setup processing, an intermediate node on the Route_Setup path forced the RTP being established to terminate on that node due to locally defined restrictions that do not allow RTPs to pass through that node. This condition should not lead to a Route_Setup failure, but instead should result in back-to-back RTPs being established at this node (rather than a single RTP that passes through this node).
- FF80
- RTP NCB not found or not valid.
- 0001
- RTP NCB not found.
- 0002
- RTP NCB state not valid.
- 0003
- Route_Setup RTP pending.
- 0004
- Route_Setup RTP not useable.
- 0005
- Route_Setup RTP not found.
- FF90
- MNPS RECOVERY stop.
- 0001
- MNPS RECOVERY stop.
- FFC8
- HPR/IP (Enterprise Extender) getaddrinfo error.
- 0001
- Hostname not found.
- 0002
- Try again–temporary error.
- 0003
- Unrecoverable error occurred.
- 0004
- HPR⁄IP (Enterprise Extender) addressing keys (LSAP, RSAP, IPADDR)
duplicate those of a preexistent connection.
VTAM® hint: Check the SAPADDR statements. They must be unique for each connection. See z/OS Communications Server: SNA Network Implementation Guide for more information about HPR⁄IP (Enterprise Extender) addressing.
- 0005
- Hostname length error.
- 0006
- getaddrinfo timeout.