ABACKUP: Preventing aggregate backup
Explanation: ABACKUP is an optional parameter specifying that the process of backing up aggregated data sets stops after completion of any currently running aggregate backup. Any ABACKUP commands not processed remain in the queue until ABACKUP is released.
Subparameter | Explanation |
---|---|
agname | ABACKUP(agname) is an optional parameter specifying an aggregate group. For agname, substitute the name of the SMS aggregate group. |
EOD | ABACKUP EOD If the EOD option
is specified with a HOLD ABACKUP command, the currently executing
aggregate backup is stopped at the end of the data set currently processing,
and the ABACKUP command is purged from the queue. All open data sets
and tapes are closed and all allocated data sets and tapes are deallocated
before the termination. The ABACKUP output files are uncataloged
and the tape volume serial numbers are removed from the HSMABR tape
volume set if they were indicated to be protected. During ABACKUP
processing, if the control file has already been written and a HOLD
EOD is issued, ABACKUP is allowed to complete normally. However, if
ABACKUP was issued with the MOVE option, ABACKUP will be held. If
an aggregate group name was specified with the HOLD ABACKUP command,
the above processing only occurs when the specified name matches a
currently running or pending ABACKUP command. If the ABACKUP parameter
is specified with the HOLD command and without the EOD option, the
currently executing ABACKUP commands run to completion. If an aggregate
group name has been specified, subsequent commands for that name are
held. When an aggregate group name was specified, the above processing
only occurs if the specified name matches a currently running or pending
ABACKUP command.
Notes:
|
Defaults: None.