Explanation
This message is the first of a group of messages.
The message group follows.
IST849I operation1 INCONSISTENT WITH USE OF operation2 IN statementname
IST701I CONFIG configname LABEL = labelname STMT TYPE = statementname
An
inconsistent connection has been made between
operation1 and
operation2. VTAM® issues message IST849I for
the following combinations of
operation1 and
operation2:
- AUTODL and SHOLD
- AUTODL=NO is coded in the GROUP or LINE definition statement.
- DIALNO and SHOLD
- DIALNO is not coded in the GROUP definition statement.
- CPNAME and PUTYPE
- CPNAME is coded for a PU type other than PU type 2.
- LOADFROM and SAVEMOD
- LOADFROM=EXT was specified on the VARY ACT command, and SAVEMOD=YES
was specified on the PCCU definition statement. This combination is
not valid.
- RESSCB and LOCADDR
- RESSCB is specified for a dependent LU.
- SAVEMOD and DUMPLD
- SAVEMOD=NO was specified on the VARY ACT command, and DUMPLD=YES
was specified on the PCCU definition statement. This combination
is not valid.
- SAVEMOD and LOADFROM
- SAVEMOD=YES was specified on the VARY ACT command, and LOADFROM=EXT
was specified on the PCCU definition statement. This combination is
not valid.
The definition statement statementname is
in the node configname and has the label labelname.
System action
The system action depends on the value of
operation1 and
operation2:
- AUTODL and SHOLD
- VTAM does one of the following:
- If AUTODL=NO is coded on the GROUP definition statement, VTAM ignores the entire GROUP definition
statement and all definition statements under it.
- If AUTODL=NO is coded on the LINE definition statement, VTAM treats all lines in that group
as ordinary X.21 switched lines, and the group is no longer a short
hold mode/multiple port sharing (SHM/MPS) group.
- DIALNO and SHOLD
- VTAM ignores the entire
GROUP definition statement and all definition statements under it.
- CPNAME and PUTYPE
- PU and subnodes are unavailable.
- LOCADDR and EAS
- VTAM ignores EAS.
- LOADFROM and SAVEMOD
- VTAM does not use SAVEMOD=YES,
coded on the PCCU definition statement, during the initial load, but
it is saved for future reloads. The automatic dump and load switches
are not changed in the NCP.
- RESSCB and LOCADDR
- VTAM ignores RESSCB.
- SAVEMOD and DUMPLD
- VTAM does not use DUMPLD=YES,
coded on the PCCU definition statement, during the initial load, but
it is saved for future reloads. The automatic dump and load switches
are not changed in the NCP.
- SAVEMOD and LOADFROM
- VTAM does not use the LOADFROM=EXT,
coded on the PCCU definition statement, during the initial load, but
it is saved for future reloads.
Operator response
Save the system log for problem determination.
System programmer response
Check and correct the definition
statement statementname.
Routing code
Descriptor code