Explanation
This message is part of a group of messages that VTAM® issues in response to a DISPLAY
ADJSSCPS command. The DISPLAY ADJSSCPS command requests information
about adjacent SSCPs used to reach the destination SSCP or CDRSC resource.
IST350I DISPLAY TYPE = ADJACENT SSCP TABLE
IST611I ADJACENT SSCP TABLE FOR resource [IN netid]
[IST1705I sc_option = sc_value FROM START OPTION]
[IST1704I sc_option = sc_value FROM ADJACENT SSCP TABLE]
IST1220I SSCPNAME NETID CURRENT STATE ROUTING STATUS
IST624I sscpname[netid] current_state routing_stat us
⋮
IST314I END
IST350I - This message identifies the type of information shown in the
display. DISPLAY TYPE is always ADJACENT SSCP TABLE in this
message group.
IST611I - resource is the name of the resource that
was specified on the CDRSC operand of the command. If a network-qualified
name was entered on the command line, VTAM issues
the network ID netid.
IST624I - VTAM issues this message
for each SSCP sscpname in the adjacent SSCP table
being displayed and identifies the names of the adjacent SSCPs associated
with resource.
- sscpname is the name of the adjacent SSCP for
which information is displayed.
- netid is displayed only if the network ID of sscpname is
known to VTAM and CDRSC is
specified on the DISPLAY command.
- current_state and routing_status are
displayed when CDRSC is specified on the command.
- For current_state information, see the z/OS Communications Server: IP and SNA Codes. **NA** is displayed if the SSCP is
not defined to VTAM.
- routing_status can be one of the following:
- FAILURE
- The most recent routing attempt to the SSCP failed.
- SUCCESS
- The most recent routing attempt to the SSCP was successful. This
does not indicate that session establishment was successful.
- **NA**
- Routing status is not available.
IST1220I - This message is displayed only when the CDRSC operand is specified
on the command and is a header message for the list of adjacent SSCPs
that follows in message IST624I.
IST1704I or IST1705I - sc_option indicates a search control option
associated with the adjacent SSCP table being displayed. Possible
values are: SORDER and SSCPORD. When VTAM is
enabled for APPN, both search control options will be displayed with
SORDER being first. When VTAM is
not enabled for APPN, SSCPORD will be the only search control option
displayed. Either IST1704I or IST1705I will be issued for each search
control option displayed.
- sc_value indicates the value of the search
control option associated with the adjacent SSCP table being displayed.
If sc_value is ADJLIST, the adjacent SSCP table
being displayed is for a resource that specified an adjacent CDRM
list (ADJLIST); therefore, the SORDER and SSCPORD search control options
do not apply .
System action
Operator response
System programmer response
Routing code
Descriptor code