The VTAM® task has abended while processing an operator command. The command cannot be identified, but it is being canceled. Recovery of the VTAM task is being attempted. See the appropriate operating system codes manual for the meaning of the hexadecimal abend code code.
VTAM processing continues.
This is probably a software error. Check the system log to determine which command was not processed. Then reenter the command that caused the failure. If the failure recurs and completion of this command is required to proceed with VTAM, halt VTAM and then start it again. Save the system log and dump for problem determination.
See the z/OS Communications Server: SNA Diagnosis Vol 1, Techniques and Procedures for information on the abend procedure.
2
3