Explanation
System action
VTAM rejects
the command.
Operator response
If you can correct the reason for the failure,
do so and reenter the command. If nodename is a
resource in another domain, the error can be in either domain. Notify
the operator of the other domain if action is required in that domain
as well.
For example,
- ACTIVATE FAILED FOR cdrmname REQUEST ACTCDRM
SENSE 08120000:
- The activation of an SSCP-SSCP session, started by an ACTCDRM
request from the other domain, failed because of insufficient storage
in this domain.
- The operator can restart the activation in this domain by issuing
a VARY ACT command for cdrmname.
- If the activation continues to fail:
- Use the MODIFY CSALIMIT command to increase VTAM’s common service area storage.
- Deactivate other network resources to provide the necessary storage.
- ACTIVATE FAILED FOR cdrmname REQUEST ACTCDRM
SENSE 084E0000:
- The activation of an SSCP-SSCP session failed because the NETID
in the ACTCDRM request or response does not match the NETID coded
in the CDRM definition.
- ACTIVATE FAILED FOR cdrmname REQUEST ACTCDRM
SENSE 08810000:
- If this host is not a gateway host, and the operator issues the
VARY ACT command for cdrmname for a gateway SSCP,
the gateway NCP sends REQACTCDRM to the gateway SSCP. The gateway
SSCP then attempts to activate the SSCP-SSCP session.
- If this host is a gateway host and in a back-to-back configuration,
the gateway NCP sends REQACTCDRM to the other gateway host to cause
the SSCP-SSCP session to be established.
For a storage problem, enter the DISPLAY BFRUSE command.
Issue the DISPLAY STORUSE command to display storage usage for storage
pools. Save the system log and dump for problem determination.
System programmer response
Verify that the operator entered
the buffer pool or CSA start options as specified in the start procedures.
Increase
storage as required. For insufficient storage errors, you might want
to redefine your buffer pool or CSA limits. If the start option cannot
be modified using the MODIFY VTAMOPTS command, you must modify the VTAM start options file (ATCSTR
xx)
and restart VTAM to use the
start option.
Routing code
Descriptor code