Explanation
VTAM® issues
this message when the command failed for nodename because
the necessary load, dump or link station was not available for one
of the following reasons:
- VTAM tried to select a
default dump or load station, and none was available.
- The load or dump station was deactivated while a load or dump
was being performed.
- VTAM was unable to establish
connectivity between nodename and any link station
in the RNAME list from the VARY ACT command.
System action
VTAM deactivates nodename and
rejects the command. Other processing continues.
Operator response
Display
nodename and all
link stations to check spelling and status. Save the system log for
problem determination.
- For reasons 1 and 2, allow VTAM to
choose the default load or dump station.
- For reason 3, activate the link stations before reissuing the
command to activate the communication controller.
VTAM will issue
other error messages for each link station that failed to establish
a connection with the communication controller. See those messages
for further help.
System programmer response
Check that the link stations in the
RNAME list are valid and can be used to establish connectivity with
the communication controller. Correct the RNAME list if needed.
Routing code
Descriptor code