IST361A

Explanation
 While processing a VARY ACT command, VTAM® found the specified nodename and subarea already
loaded with NCP load module loadmodname or already
defined for subarea. If the load module is not
known, VTAM displays ***NA***
for loadmodname.
 VFYLM=YES was specified
on the NCP’s PCCU definition statement. The operator might therefore
decide to reload the specified communication controller or terminate
the activation.
 Note: VTAM continues
to issue message IST361A until you enter a correct response.

System action
 Processing continues.

Operator response
 Reply ‘YES’ if you want to reload
the communication controller.  Other VTAMs sharing the communication
controller will be affected when you reload.
 Reply ‘NO’
if you want to stop the activation of the communication controller.
 This will result in a load module mismatch between the load module
that is active for this VTAM and
the load module that is active for another VTAM which is sharing the same communication
controller.

System programmer response
 None. 
 Note: For additional information
on how to respond to this message, see Responding to a VTAM message.

Routing code
 2

Descriptor code
 2 