Explanation
A DISPLAY EEDIAG,TEST=YES command was issued to
perform an Enterprise Extender connectivity test, but no dial out
line was available. At least one EE line associated with the local
static VIPA address you are testing must be active and available
for use. The EE connectivity test requires an available line to
conduct the test even if the connection you are testing has an active
EE connection over another EE line.
System action
The DISPLAY EEDIAG,TEST=YES command is not performed.
Operator response
To use the EE connectivity test, perform
the following actions to activate an Enterprise Extender line:
- If EE lines in the EE XCA major node group associated with the
local static VIPA address are defined but not currently active,
issue a V NET,ACT,ID=groupname,SCOPE=ALL
command to activate these lines.
- If lines were activated, issue the DISPLAY EEDIAG,TEST=YES command
again.
- If no lines are available to perform the EE connectivity test,
contact your system programmer.
System programmer response
Update the EE XCA major node to define
additional lines that you need to use the EE connectivity test.
- If you defined a new group with additional lines, the operator
can dynamically activate a new group in the EE XCA major node. Issue
the V NET,ACT,ID=eexcamajornode,UPDATE=ALL
command. See z/OS Communications Server: SNA Operation for more information about using the VARY
command.
- If you defined additional lines to an existing group, activating
the new lines might be disruptive to existing EE connections. If
this is acceptable, the operator can perform one of the following
to activate the newly defined lines:
- To dynamically update an EE XCA major node group, issue the V
NET,INACT,ID=eegroupname,F command
to deactivate all existing lines in the modified group. When
the EE group is inactive, issue the V NET,ACT,ID=eexcamajornode,UPDATE=ALL
command to dynamically update the group. Issue a V NET,INACT,ID=eexcamajornode,F
command to deactivate Enterprise Extender. See z/OS Communications Server: SNA Operation for more information about using
the VARY command.
- Issue a V NET,ACT,ID=eexcamajornode,SCOPE=ALL
command to activate the modified Enterprise Extender definitions.
When the lines are defined and activated, the operator
can issue the DISPLAY EEDIAG,TEST=YES command again.
User response
Problem determination
Source
z/OS® Communications
Server SNA
Module
Routing code
Descriptor code