IST2103I
RSCV TOWARDS SLU

Explanation

This message is part of a subgroup of messages that VTAM® issues in response to a session setup failure. This message subgroup is displayed in a message group headed by IST663I.

This message indicates that the messages that follow describe part or all of the session path for this session as it was calculated during session initiation. The session path information describes the portion of the route originating at this node, or a subarea node connected to this ICN, and extending towards the CP (SLU). This message subgroup is displayed only if session path data was saved during session initiation and the session initiation fails for either of the following reasons:
  • Trial and error routing using an adjacent SSCP table failed. The destination LU was found by an SSCP, but that SSCP rejected the session initiation with a non-reroutable sense code.
  • Trial and error routing using an adjacent SSCP table exhausted the table. All adjacent SSCPs were tried, but the destination LU was not known to any of the SSCPs.
A complete description of the message subgroup follows.
IST2103I RSCV TOWARDS SLU
IST1460I TGN  CPNAME             TG TYPE      HPR
IST1461I tgn  cpname             tgtype       hpr
⋮
IST1460I
  • This message is a header message for information displayed in message IST1461I.
IST1461I
  • The route selection control vector (RSCV) is displayed showing a portion of the route towards the CP (SLU). Multiple IST1461I messages might be needed to display the portion of the route known by this node.
  • tgn is the transmission group number.
  • cpname is the destination CP name for the transmission group.
  • tgtype is the transmission group type. The values for tgtype can be:
    APPN
    Indicates that this TG is an APPN-based TG.
    INTERCHANGE
    Indicates that this TG represents a TG from an interchange node to a subarea node.
    VRTG
    Indicates that this TG is a virtual-route-based TG.
    ISL
    Indicates that this TG is an intersubnet TG.
  • hpr corresponds with the HPR start option. The values for hpr can be:
    RTP
    Indicates that this node provides RTP-level HPR support.
    ANR
    Indicates that this node provides ANR-level HPR support.
    *NA*
    Indicates that this node provides no HPR support.
IST2103I
  • This message is a header message for information displayed in messages IST1460I and IST1461I.

System action

The session initiation failed.

Operator response

Save the system log for problem determination.

System programmer response

Use the output to determine the cause of the problem. Work with the system programmers for other networks to determine the cause of failures for resources located in other networks.

Source

z/OS® Communications Server SNA

Module

You can display the module that issues a SNA message in the message by setting the MSGMOD start option to YES. See Adding the originating module to the message text for more information about the MSGMOD start option.

Routing code

8

Descriptor code

4