IST1865I

Explanation
 This message is the first in a group of messages
in response to the DISPLAY  INOPDUMP or MODIFY INOPDUMP commands.
Possible message groups follow:  In response to a DISPLAY INOPDUMP command:     IST350I DISPLAY TYPE = INOPDUMP
 IST1865I GLOBAL INOPDUMP = status 
[IST924I  ----------------------------------]
[IST1954I TRL MAJOR NODE = trl_major_node_name]
[IST1866I TRLE = trlename INOPDUMP = ON]
⋮
 IST314I  END

In response to a MODIFY INOPDUMP command:     IST1865I GLOBAL INOPDUMP = status 
[IST1866I TRLE = trlename INOPDUMP = status] 
⋮
[IST1867I INOPDUMP = status FOR ALL TRLE BASED RESOURCES]  
 IST223I MODIFY COMMAND COMPLETE
 IST314I  END

In response to a MODIFY VTAMOPTS, INOPDUMP command:   IST1865I GLOBAL INOPDUMP = status 
IST1867I INOPDUMP = status FOR ALL TRLE BASED RESOURCES 
IST314I  END

 IST223I  VTAM® issues this message
when the MODIFY command has successfully completed.

 IST350I  This message identifies the type of information shown in the
display. For this message group, type is always INOPDUMP.

 IST1865I  status can be one of the following:  ON indicates that all active non-TRLE controlled resources might
attempt to  initiate an automatic VTAM dump
when an inoperative condition is detected. 
OFF indicates that no active non-TRLE controlled resources will
attempt to  initiate an automatic VTAM dump
when an inoperative condition is detected. 

The global INOPDUMP status is the default used to initialize each
TRLE-based  resource INOPDUMP status when the TRLEs are activated.

 IST1866I  If you receive this message in response to a DISPLAY INOPDUMP
command, it will appear once for each TRLE with INOPDUMP=ON.
trlename is the name of the TRLE for which
status is being reported.  
status can be one of the following:  ON  indicates that the resources defined in the TRLE might attempt
to  initiate an automatic VTAM dump
when an inoperative condition is detected. 
OFF indicates that the resources defined in the TRLE will not
attempt to  initiate an automatic VTAM dump
when an inoperative condition is detected.

 IST1867I  status can be one of the following:   ON indicates that the INOPDUMP status for every TRLE in all active
predefined TRL major nodes has been set to ON. 
OFF indicates that the INOPDUMP status for every TRLE in all active
predefined TRL major nodes has been set OFF.

This message is a reminder to the operator that use of the MODIFY
 VTAMOPTS,INOPDUMP command or a global MODIFY INOPDUMP command also
sets the  INOPDUMP status for each TRLE in all active predefined TRL
major nodes. However, if there are no active predefined TRL major
nodes, this message will not appear in the response.

 IST1954I  trl_major_node_name is the name of the TRL
major node defining the TRLE for which status is being reported. 
This message is issued once for each active predefined TRL major
node.

System action
 Processing continues

Operator response
 None.

System programmer response
 None.

Routing code
 2

Descriptor code
 5