IST1610I

Explanation
 This message is issued in a message group with
message IST605I. A complete description of the message group follows
the example.  IST605I  ERROR FOR ID = nodename – text1 : text2
IST1610I  CORRELATOR MISMATCH – LOAD=NO
IST314I  END

 IST605I
 A response sent
by nodename contained invalid data.
 text1 : text2 specifies
the RU in error, and is RESPONSE :  ACTPU for this message
group.
 IST1610I
 The VARY ACT command defaulted
to or specified LOAD=NO, and the generated correlator did not match
the correlator loaded in the communications controller.

System action
 nodename is deactivated. 

Operator response
 Save the system log for problem determination. 

System programmer response
  If the node should be activated, reactivate it.
If the problem persists, try to create the problem again while
an I/O trace or buffer trace is running for the affected nodename.
If nodename is link-attached, run a line trace
for the affected line.  Enter a MODIFY TRACE,ID=nodename command.

Routing code
 2

Descriptor code
 5