IST150I
RRT LOAD MODULE rrtname DOES NOT CONTAIN RESOURCE SEGMENT [EXTENSION]

Explanation

While processing definition statements, VTAM® could not find the resource segment or resource segment extension in the resource resolution table (RRT) named rrtname. The RRT was produced during NCP generation. VTAM uses the resource segment (together with its entries) to correlate a minor node with its network address, and uses the resource segment extension to correlate the name of a physical unit type 4 with a transmission group number. Both the resource segment and resource segment extension are stored in the data set where the NCP load module is linked.

System action

The activation of the NCP fails. Processing continues.

Operator response

You can use the network only if the NCP is not essential. Save the system log for problem determination.

System programmer response

Do one of the following:

  1. If the NCP generation process did not complete successfully, check the output from the NCP generation to see whether the resource resolution table was produced. If it was, restart VTAM definition processing. If it was not, regenerate the NCP, restart VTAM definition processing.
  2. If the resource resolution table has been damaged, take a dump of the RRT load module to determine whether it contains a resource segment or resource segment extension or both.

In either case, correct or reproduce the RRT load module by regenerating the NCP. Restart the VTAM definition processing.

Routing code

2

Descriptor code

5

Parent topic: IST messages for VTAM network operators IST001I – IST399I