IST1486I

Explanation
 VTAM® issues
this message as part of a group of messages in response to a DISPLAY
ADJCP ID= command for an adjacent control point (ADJCP) that has a
Rapid Transport Protocol (RTP) connected to it or in response to a
DISPLAY ID= command where ID is the name of the RTP major node.
 This
message is the first in a group of messages and the full description
of the message group follows the example.  IST1486I RTP NAME   STATE              DESTINATION CP  MNPS   TYPE
IST1487I puname     state              nodename        mnps   type
⋮
 IST1486I
 This message is a header
message for the information displayed in message IST1487I.
 IST1487I
 puname is
the RTP PU NAME of the adjacent link station (RTP ALS).
 state is
the connection state of the RTP and can be one of the following:  INITIAL
Initial state at startup time
ALS_PENDING
Waiting for adjacent link station processing
ALS_ASSIGNED
Adjacent link station processing is complete
OPENED
Initial state for active partner after startup
CALLING
Active partner sending connection setup to the passive partner
LISTENING
Initial state for passive partner after startup
CONNECTED
RTP is active
DISCONNECTED
Disconnect processing is complete and last message has been sent
DISCONNECT
Disconnect processing is in progress
PENDING_ACT
Waiting for activation to complete
PENDING_INACT
Waiting for inactivation to complete
PENDING_INACT
Waiting for inactivation to complete
PENDING TAKEOVR
Multinode persistent session application program planned takeover
is in progress
RECOVERY
Multi-node persistent session application program recovery in
progress

 nodename is the destination
partner's name in the form of netid.name for this
RTP.
 mnps indicates if the RTP connection
is being used by an MNPS application and can be one of the following:
 YES
The RTP connection is being used by an MNPS application.
NO
The RTP connection is not being used by an MNPS application.

 type indicates the type
of RTP connection and can be one of the following:  CPCP
CP_CP RTP
RSTP
Route_Setup RTP
LULU
LU_LU RTP

System action
 Processing continues.

Operator response
 None.

System programmer response
 None. 

Routing code
 2

Descriptor code
 5