IST1382I
REBUILD HAS BEEN STOPPED FOR STRUCTURE structure

Explanation

VTAM® issues this message to indicate that a rebuild has been stopped before it could complete. There are two reasons a rebuild will be stopped:
  • The operator entered the MVS™ SETXCF STOP,REBUILD command.
  • VTAM has determined that there is an insufficient number of connectors to the new structure to continue.
  • A connector to the original structure may have a failed persistent connection and a connection may remain failed persistent if all affinities are not deleted.

structure is the name of the coupling facility structure.

System action

VTAM continues to use the old structure. Processing continues.

Operator response

If SETXCF STOP,REBUILD was not entered, save the system log for problem determination.

If the rebuild is stopped because of a failed persistent connection either reestablish the failed connection and allow the responsible application to purge the affinities or enter the MVS SETXCF FORCE, CONNECTION, CONNAME=conname, STRNAME=structure name command to force the failed persistent connection away.

System programmer response

If the operator did not enter the SETXCF STOP,REBUILD command, make sure all nodes in the sysplex have connectivity to the coupling facilities defined in the active coupling facility policy. A rebuild might be tried again by using the SETXCF START,REBUILD command.

Routing code

2

Descriptor code

5

Parent topic: IST messages for VTAM network operators IST1200I – IST1599I