Explanation
VTAM® stopped
processing the
command. VTAM could not define the resource
nodename for
one of the following reasons:
- nodename has the same name as another resource
in this domain.
- nodename has the same network address as another
resource in this domain.
- The value for VNNAME for nodename matches the
value for CPNAME on a PU in this domain.
- The value for VNNAME for nodename refers to
an ADJCP for which VN=YES is not specified.
command is the command that failed.
See Command and RU types in VTAM messages for a description of command.
nodename is
the name of the resource specified on the command. If nodename is
session-capable, VTAM issues nodename as
a network-qualified name in the form netid.name.
System action
VTAM rejects
the command.
Operator response
Display
nodename:
- If the resource already exists, command failed
because the resource was already defined.
- If nodename is a communication controller,
enter a DISPLAY STATIONS command.
- If the subarea of nodename is listed as an
adjacent subarea in the display, another communication controller
has been defined for that subarea. The communication controller might
still exist if the link to that subarea is still active. To correct
the problem, enter a VARY INACT command for the link to the adjacent
subarea.
- If the resource does not exist, display VNNAME. If VNNAME already
exists, command failed because the VNNAME was already
defined with a different nodetype.
Save the system log for problem determination.
System programmer response
Routing code
Descriptor code