A complete description of this message subgroup follows.

IST1065I LOAD MODULE  REQUESTED IPL  ESTIMATED IPL
IST1066I load_module  requested_time estimated_time
⋮

This subgroup is issued when an IPL has been scheduled for at least one load module on the disk. IST1066I is repeated for each load module.

• If there is only one load module with a scheduled IPL, VTAM issues message IST1066I for this load module. In addition, IST1066I is repeated for all load modules even if they do not have a scheduled IPL. An example follows:

  IST1065I  LOAD MODULE  REQUESTED IPL  ESTIMATED IPL
  IST1066I  load_module  requested_time  estimated_time
  IST1066I  load_module  ***NA***        ***NA***
  IST1066I  load_module  ***NA***        ***NA***

• If there are no load modules with a scheduled IPL, VTAM does not issue the subgroup.

estimated_time is the time the IPL will take place as calculated by VTAM. This time reflects the time zone where DISPLAY DISK was entered. Differences between requested_time and estimated_time can be caused by the following:

• The MODIFY LOAD and DISPLAY DISK commands were entered in different time zones.
• There was a network delay between VTAM and NCP when the MODIFY LOAD was entered. In this case, estimated_time is the actual IPL time.
• There is a network delay between VTAM and NCP when the DISPLAY DISK is entered. In this case, the actual IPL time will be earlier than estimated_time.
• The host system clock was adjusted between the time MODIFY LOAD was entered and the time DISPLAY DISK was entered.