Using the batch option

You can access the VTAM® dump analysis tools by using the batch option. These steps provide the minimum information that you need to use the batch option.

Before you begin

You need to find the data set name of the dump to be analyzed. (This name must be specified in the JCL.)

Procedure

Perform the following step to access VTAM formatted dump using the batch processing interface.

Prepare the JCL data set. See Table 1 to determine what document describes IPCS.
Examples: Sample command (single command):
```
VERBEXIT VTAMMAP 'RDTFULL'
```
Sample command (multiple commands):
```
VERBEXIT VTAMMAP 'RDTFULL'
VERBEXIT VTAMMAP 'SIBCHECK ADDR(X''01267B8'')'
```
_________________________________________________________________
Submit the JCL so the job will execute.
_________________________________________________________________

Results

You know that you are done when the job completes.