IRRM030I

Explanation
The keywords SYSNAME and MAIN were specified on
a TARGET command that refers to an already existing TARGET definition
describing a single-system node. Because SYSNAME and MAIN were specified
on the TARGET command, RACF® assumes
that the single-system node is being redefined to be a multisystem
node. This message is issued if either of the following conditions
occurs: You are redefining a remote single-system node to be a multisystem
node, and the node is not in either the dormant or initial state.
You are redefining a local single-system node to be a multisystem
node, and one of its remote nodes is in a state other than the dormant
or initial state.

System action
The TARGET command is ignored.

Operator response
If the single-system node is to be changed
to a multisystem node, node-name must be in the
dormant or initial state. Reissue a corrected version of the command.

Routing code
None.

Descriptor code
6