IRRI016I

node-name

Explanation
RACF® successfully
made a connection between the local node and a remote RRSF node. However,
there is an inconsistency in the TARGET statements on the local and
remote nodes. The text of this message indicates the node and system
name in conflict and the reason code indicates the inconsistency.
The reason code is one of these values:Reason

1
There is no agreement on a node name. This can occur normally
when adding node that is not defined using the TARGET command on the
remote system.
2
There is no agreement if a node is a multisystem node or a single-system
node.
3
There is no agreement on system-name.
4
There is no agreement if the system on the multisystem node is
the MAIN system.
5
There is no agreement about the transport protocol being used
for the connection.

System action
Because these are errors, RACF does not move this node pair into the OPERATIVE-ACTIVE
state. Instead they are left in an OPERATIVE-PENDING-VERIFICATION
state. Message IRRI013I is displayed and indicates that RACF does not communicate with the partner node.

Operator response
Do the following tasks:Issue the TARGET LIST command from both nodes and determine the
error. If a node is multisystem, ensure that the TARGET LIST command
is issued from the specific system involved.
Issue the TARGET DELETE command for the incorrect node definitions
and issue TARGET commands to define the deleted nodes correctly. If
a node is multisystem, ensure that the corrections are made on every
system.
Ensure that corresponding updates are made to the RACF parameter library for future refreshes
of the subsystem or reIPLs.

Routing code
2

Descriptor code
6