IRR916I

Explanation
 This message is issued when the DB2® V9 RACF® access
control module is used, to indicate whether the module supports DB2 roles.
The module does
not fully support DB2 roles
if it is invoked from a DB2 V9
system and any of the following sets of conditions are true:The system is running z/OS® V1R7
and the RACF access control
module was assembled with z/OS V1R7
macros.
The system is running z/OS V1R7
and the RACF access control
module was assembled with z/OS V1R8
macros.
The system is running z/OS V1R8
and the RACF access control
module was assembled with z/OS V1R7
macros.

The module fully supports DB2 roles
if it is invoked from a DB2 V9
system and the following set of conditions is true:The system is running z/OS V1R8
and the RACF access control
module was assembled with z/OS V1R8
macros.

System action
The RACF access
control module continues.

System programmer response
Reassemble the RACF access control module with the HRF7730
or later macro library to fully enable ROLES support in the module
when DB2 is running on z/OS V1R8 or later. The DB2 V9-shipped version must be assembled
with the DB2 V9 macros, link
edited, and installed in a library that is accessible to your DB2 subsystem.

Routing code
9 and 10

Descriptor code
4