Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
ICH15037I z/OS Security Server RACF Messages and Codes SA23-2291-00 |
|
ICH15037I IN CLASS GXFACILI, AN IRRPLEX PROFILE WAS ENCOUNTERED ON
THE DATABASE WITH MASTER DATA SET DSNAME, BUT THE
SYSPLEX NAME PORTION OF THE PROFILE NAME WAS GREATER THAN 8 CHARACTERS.
DATABASE SHARING CHECKS HAVE IGNORED PROFILE IRRPLEX_SYSPLEX-NAME. ExplanationFor each unique sysplex name, there might exist one IRRPLEX profile. These profiles contain APPLDATA information, and are used by the routines, which protect the database from being used in an incorrect sharing environment, to prevent database corruption. A sysplex name is limited to eight characters in length. No information from this profile is considered by the anti-corruption scheme. A maximum of the first 20 characters of the profile name is presented in the message. System actionThe system continues processing. Operator responseContact your system programmer. System programmer responseIRRPLEX_sysplex-name profiles are used by the routines that protect the database from bad sharing. If the names of profiles in the GXFACILI class begin with “IRRPLEX_”, they might remain if the environment has other uses for them, and this message can be ignored. If a sysplex, which runs at code levels less than in z/OS® R10, shares this database (RVARY LIST from the security console), and you manually created the profile to ensure that the code, which shields the database from bad sharing, gets more pertinent information, you must issue an RDELETE command on the profile and reissue the command with a valid 8-character sysplex name. Systems running release z/OS R10 or later, automatically create and maintain these profiles. If the message indicates
the backup database, and you did not receive this message for the
primary database, then if the backup database is intended to be the
same as the primary database, resynchronize the primary and the backup
databases using "IRRUT200 PARM=ACTIVATE".
Note: Ensure that the database
you are using as the backup database is the correct database to be
using with your primary database. The "IRRUT200 PARM=ACTIVATE" overlays
all the data within the specified backup data set. See z/OS Security Server RACF System Programmer's Guide for
more information about IRRUT200.
If the problem persists, contact
your IBM® support center.Do not use RRSF to propagate the RDEFINE, RALTER, and RDELETE commands to other databases. If automatic command direction is enabled for the GXFACILI class, use the ONLYAT operand (on the RALTER, RDEFINE, and RDELETE commands) when you change IRRPLEX_sysplex-name profiles to prevent this propagation. ONLYAT must be used whether you are altering, creating, or deleting the class GXFACILI IRRPLEX_sysplex-name profiles on a local or remote node. Routing code2 and 9 Descriptor code4 |
Copyright IBM Corporation 1990, 2014
|