IRRI006I

Explanation
This is a warning message only.  You can choose
whether to act immediately. RACF® checks
certain data between the partner node and the local node to determine
whether a command could run on one node but not the other.  The indicated
SETROPTS option is one of these types of data and a mismatch is detected.
Adding a profile on one node may work, but fail on the other node
until the corresponding SETROPTS options match.

System action
If no error messages are issued with this warning
message, RACF still attempts
to move this node pair into the OPERATIVE ACTIVE state. Message IRRI001I
tells you when the OPERATIVE ACTIVE state is reached.

System programmer response
Evaluate the SETROPTS options in the
message. These SETROPTS options must match when you want two RACF nodes to communicate with
each other. You should use the SETROPTS command to change one or both
nodes so that the SETROPTS options match. When the SETROPTS options
match, this message does not appear when the two nodes TARGET each
other.

Routing code
2 and 9

Descriptor code
4