Permission rejected: The receiver has denied an implicit
or explicit request of the sender; when sent in response to BIND,
it implies either that the secondary LU will not notify the SSCP when
a BIND can be accepted, or that the SSCP does not recognize the NOTIFY
vector key X'0C'. (See the X'0845' sense code for
a contrasting response.)
Bytes 2 and 3 following the sense code contain sense-code-specific
information.
- 0000
- No specific code applies.
- 0001
- An SSCP has denied permission to establish a session through its
resources; the receiving SSCP should not attempt to reroute the request
to another SSCP.
- 0002
- An SSCP has denied permission to establish a session through its
resources; the receiving SSCP should attempt to reroute the request
to another SSCP.
- 0005
- The alias application has denied permission to establish a session
through this SSCP. The receiving SSCP should not attempt to reroute
the request to another SSCP.
- 0006
- The alias application has denied permission to establish a session
through this SSCP. The receiving SSCP should attempt to reroute the
request to another SSCP.
- 0007
- Permission rejected for an activation request received for a resource
that has a network ID different from that of the requesting SSCP,
and the requesting SSCP indicated previously that it does not support
this configuration.
- 0008
- The request specified in the request change control MS major vector
was rejected because it did not originate from a valid focal point.
VTAM® hint: This
sense code can be displayed in a VTAM message,
but is set by another product.
- 0009
- The request specified in the request change control MS major vector
was rejected because the ability to support it has been disabled at
the receiver.
VTAM hint: This
sense code can be displayed in a VTAM message,
but is set by another product.
- 000A
- The request was rejected because it would prohibit compliance
with the status-reporting requirements specified in the reporting
level MS common subvector.
- 000B
- The request was rejected because the second-level application,
though recognized, operates under the control of a program other than
that which has received and is to forward the request to that second-level
application program.
- 000C
- The request was rejected because the timer/clock at the receiver
is protected and cannot be set by the request sender.
- 000D
- An SSCP or CP has denied a locate search request. The receiving
SSCP or CP should attempt to reroute the request.
- 000E
- The request was rejected because of constraints or policies specific
to the receiving implementation or installation. The request
should not be tried again.
- 000F
- The request was rejected because of constraints or policies specific
to the receiving DLUs. The request should not be tried again.