Bytes 2 and 3 following
the sense code contain sense-code-specific information.
0001
HPR routing not required.
0002
HPR routing failed.
FF10
Values not defined.
0001
Route values not defined.
FF20
Problem with connection setup signal.
0001
Connection setup signal not present.
FF30
Route setup record not found or has an error.
0001
Route setup record not found.
0002
Route setup record found, but has an error.
FF50
ADJCP not found.
0001
ADJCP not found.
0002
Survivable CV46 error set when CPNAME in CV46 is the same as CPNAME
in CV44.
0003
VRBLK not found.
FF60
DLC NCB not found.
0001
DLC NCB not found.
FF70
RTP ALS not found or address failed.
0001
RTP ALS not found.
0002
RTP ALS network address in use.
0003
RTP ALS CIDCTL ADD HOSTNODE failed.
0004
RTP ALS state change in progress.
0005
RTP ALS CIDCTL ADD NEXTNODE failed.
0006
RDTADD new address failed.
0007
Our NCE Instance Identifier has changed.
0008
SLOCATE failed.
0009
During Route_Setup processing, an intermediate node on the Route_Setup
path forced the RTP being established to terminate on that node due
to locally defined restrictions that do not allow RTPs to pass through
that node. This condition should not lead to a Route_Setup failure,
but instead should result in back-to-back RTPs being established at
this node (rather than a single RTP that passes through this node).
FF80
RTP NCB not found or not valid.
0001
RTP NCB not found.
0002
RTP NCB state not valid.
0003
Route_Setup RTP pending.
0004
Route_Setup RTP not useable.
0005
Route_Setup RTP not found.
FF90
MNPS RECOVERY stop.
0001
MNPS RECOVERY stop.
FFC8
HPR/IP (Enterprise Extender) getaddrinfo error.
0001
Hostname not found.
0002
Try again–temporary error.
0003
Unrecoverable error occurred.
0004
HPR⁄IP (Enterprise Extender) addressing keys (LSAP, RSAP, IPADDR)
duplicate those of a preexistent connection.