The following is an example of a report generated by a XQUERY STORAGECONTROL command with the
XFEATURE parameter. The report includes information about workload-based write pacing. Several
fields are highlighted and are described further following the
example.
ANTQ8202I XQUERY STORAGECONTROL_XFEATURES REPORT - 001
ANTQ8370I T LIC FEATURES
ANTQ8371I SSID Y LEVEL FU D W SL ER IR EX WP
ANTQ8203I ------------------------------------------------------
ANTQ8372I 7B74 U 5.3.1.172 YY N N NN YN Y ED YY
ANTQ8372I 7B76 S 5.3.1.172 C* C C C* C* C ** C*
ANTQ8375I UTL=1 SUTL=1
ANTQ8231I DATA CONSISTENT(NO_TIME_AVAILABLE) IDLE(00:00:22.6)
ANTQ8201I XQUERY STO_XFEATURES REPORT COMPLETE FOR SESSION(A)
The
information related to workload-based write pacing is as follows:
- TY shows the type of utility: U for standard utility or S for swap
utility.
- WP is the workload-based writing pacing status.
- The fist character is the microcode status: - if the microcode support is not loaded into the
storage controller and Y if the microcode support has been activated.
- The second character is the software status: N if parmlib parameter WorkloadWritePacing is not
active, and Y if parmlib parameter WorkloadWritePacing parameter is active.
- Message ANTQ8375I shows the total number of utilities and swap utilities in the session.
- Message ANTQ8372I, the swap utility detail line, shows these values:
- For hardware features: C if it is capable and - if it is not installed.
- For software features: * (XRC is not managing the devices).
