The actual XRC error recovery process depends on both of the following
conditions:
- The specific failure condition and
- The error level that is specified for that volume pair.
You can specify the default error level for the entire session
when you start the XRC session by issuing the XSTART command and specifying
the ERRORLEVEL parameter. You can also change the error level for
specific volume pairs when you issue the XADDPAIR command with the
ERRORLEVEL parameter specified. The ERRORLEVEL parameter aids in the
error recovery process. It does not cause session errors.
To specify how XRC processes certain error conditions, use one
of the following ERRORLEVEL subparameters:
- VOLUME
- SESSION
- group_name
For additional information about the XSTART and XADDPAIR commands
and their parameters, refer to XSTART–Starting a session and XADDPAIR–Adding volume pairs or utility volumes.