URL filtering and the user authentication portal rule features work only if you configure
an IP address on the appliance protection pair.
About this task
You must configure an IP address on the appliance protection pair so that the following
features work:
- URL filtering
- “Authenticate (Reject)” action in the network access policy rule (also known as a user
authentication portal rule)
Procedure
- In the LMI, click .
- On the Protection Interfaces page, select the protection interface pair
segment (example: 1.1-1.2), and then click Edit.
- In the Edit Interface Settings window, click the IPv4
Settings tab and configure the following settings:
- Address: An unused IP address on the client network (example:
192.168.51.100).
- Netmask
- Gateway
- Click Submit. The deployment banner is displayed.
- In the deployment banner, select Click here to review the changes or apply them to
the system. The Deploy Pending Changes window is displayed.
- In the Deploy Pending Changes window, click Deploy
to deploy the changes.
What to do next
Configure the user authentication portal to work on a virtual network.