You can install a settings snapshot during first time configuration
to restore prior configuration and policy settings.
About this task
You can download a settings snapshot to restore the
IBM QRadar
Network Security appliance in case of system failure. You can also apply
a settings snapshot that you downloaded from another appliance.
Procedure
- On the Settings Snapshots page, click Browse.
- In the Snapshots pane, use one or more of the following
commands:
| Option |
Description |
|---|
| New |
To create a snapshot, click New, type
a comment describing the snapshot, and then click Submit. |
| Edit |
To edit the comment for a snapshot, select the snapshot, click Edit, type a new comment, and then click Submit. |
| Delete |
To delete snapshots, select one or more snapshots, and then
click Delete. |
| Apply |
To apply a snapshot, select the snapshot, and then click Apply. Note: If configuration or policy versions are newer
than the firmware version, the settings are rejected. If the configuration
and policy versions are older than the firmware version, the settings
are migrated to the current firmware version.
|
| Download |
To download a snapshot, select the snapshot, click Download, browse to the drive where you want to save
the snapshot, and then click Save. Note: If
you download multiple snapshots, the snapshots are compressed into
a .zip file.
|
| Upload |
To upload snapshots, click Upload,
browse to the snapshots you want to upload, select the snapshots,
and then click OK. Note: You can only upload
one snapshot at a time.
|
| Refresh |
To refresh the list of snapshots, click Refresh. |