CLI initial appliance settings wizard
The initial appliance settings wizard runs the first time an administrator logs in to the command-line interface (CLI) of an unconfigured appliance.
Navigation
You can move between screens in the wizard using the following options:- p: Previous Screen
- n: Next Screen
Modules
You must configure the following modules to set up your appliance:| Module | Description |
|---|---|
| Welcome | Describes the appliance settings that you can configure using the wizard. |
| Software License Agreement | Describes the appliance license agreement, machine code terms, IBM® terms, and non-IBM terms. |
| FIPS mode | Allows you to enable FIPS mode, if necessary. If you finish
the initial setup without enabling FIPS mode, you cannot enable it
later without reinstalling the appliance. When you enable FIPS mode,
the appliance restarts to run the required integrity checks. After
the appliance restarts, log in again to continue the setup process. Note: Do
not enable FIPS mode if you do not need to be compliant with FIPS
or if your firmware is not FIPS certified.
|
| Password Configuration | Allows you to change your password. |
| Host Configuration | Allows you to change the host name. |
| Management Interface Settings | Allows you to configure the management network interfaces. Displays device settings and the current working-set policy for the primary and secondary interfaces. |
| DNS Configuration | Allows you to configure the DNS servers used by the appliance. |
| Time Configuration | Allows you to configure the time, date, and time zone on the appliance. |
| FIPS TLS Configuration Note: This module appears only if you
have enabled FIPS mode.
|
Allows you to configure Transport Layer Security (TLS) communication for browsers connecting to the LMI. |