switchmgr
You must have start and stop access to the backup domain manager.
The switchmgr command must only be used as part of specific procedures for switching domain management capabilities from a domain manager to its backup domain manager either permanently or temporarily. For information about these procedures, refer to the Tivoli® Workload Scheduler: Administration Guide.
Syntax
{switchmgr | switchm} domain;newmgr
Arguments
- domain
- Specifies the domain in which you want to switch managers.
- newmgr
- Specifies the name of the new domain manager. This must be a workstation in the same domain, and should be defined beforehand as a fault-tolerant agent with Resolve Dependencies and Full Status enabled.
Comments
The command stops a specified workstation and restarts it as the domain manager. All domain member workstations are informed of the switch, and the old domain manager is converted to a fault-tolerant agent in the domain.
The next time JnextPlan is run on the old domain manager, the domain acts as though another switchmgr command had been run and the old domain manager automatically resumes domain management responsibilities.
- Unlink and then link the agent from the new master domain manager.
- Use the securitylevel = force option on the agent.
Examples
switchmgr masterdm;orca
switchmgr bldg2;ruby
See also
- From the navigation bar, click .
- Select a task to monitor workstations.
- Choose an engine name, or specify connection properties, and click OK.
- From the table containing the list of workstations, select a workstation and click .