SEND PARTNSET
Associates the partition set specified by the PARTNSET option with the application program.
Description
SEND PARTNSET associates the partition set specified by the PARTNSET option with the application program. If the partition set name is omitted, the terminal is reset to the base (unpartitioned) state. This command is available on standard and full BMS only. For further information about BMS, see Basic mapping support.
Note: A
SEND PARTNSET command must not be followed immediately by a RECEIVE
command. The two commands must be separated by a SEND MAP, SEND TEXT,
or SEND CONTROL command, so that the partition set is sent to the
terminal.
Conditions
The following conditions may occur together. If both occur, only the first one is passed to the application program.
- 64 INVPARTNSET
- occurs
if the partition set named in the SEND PARTNSET command is not a valid
partition set (for example, it may be a mapset).
Default action: terminate the task abnormally.
- 16 INVREQ
- RESP2
values:
- 200
- Command not allowed for a distributed program link server program.
also occurs (RESP2 not set) in the following situation:- A SEND PARTNSET command is issued while a logical message is active.
Default action: terminate the task abnormally.