QRadar Network Insights 1920-C
The IBM® QRadar® Network Insights 1920-C (MTM 4654-F4F) appliance provides detailed analysis of network flows to extend the threat detection capabilities of IBM QRadar.
The appliance has two Napatech cards, each with four ports. By default, the four ports on the first network capture card are configured for inbound traffic from the network tap. If the appliance is included in a stack, the ports are reconfigured for 2 inbound and 2 outbound. For more information about cabling stacked appliances, see the IBM QRadar Network Insights Installation Guide.
The second Napatech card is cabled internally for load balancing and cannot not be used. If you use these ports when you cable the appliance, you do not get any data.
The following table shows the hardware information and requirements for the IBM QRadar Network Insights 1920-C (MTM 4654-F4F) appliance.
| Description | Value |
|---|---|
| CPU | 2 x Xeon Gold 6132 14C 2.6 GHz 19 MB Cache 3.70 GHz 140 W |
| Network capture transceivers |
2 x 10 Gb Short Range fiber Transceivers (Avago AFBR-703SDZ or AFBR-709SMZ) 2 x 1 G TX RJ-45 Transceivers (Avago ABCU-5710RZ or ABCU-5740RZ) 2 x 1 G SX LC Transceivers (Avago AFBR-5715PZ) Use these transceivers with the network packet capture card, labeled as [2] in the appliance diagram. |
| Network management transceivers |
2 x 10 GbE Short Range SFP+ The transceivers can have one of the following part numbers:
Use these transceivers with the 2 x 10 GbE SFP+ ports, labeled as [3] in the appliance diagram. |
| Ports |
Network Packet Capture (SFP/SFP+) port (Model NT40E3-4) 4 x 1 Gb Ethernet ports 1 x RJ-45 10/100/1000 Mb Ethernet systems management (IMM) port 2 x 10 Gbps SFP+ management ports |
| Memory | 128 GB, 8 x 16 GB |
| Storage | 2 x 240 GB SATA 2.5" SSD, 240 GB Total (RAID1) |
| Traffic rate | 10 Gbps |
| Power supply | Dual redundant 750 W AC |
| Unit weight | 73 lbs |
| Physical dimensions | 29.0 inches deep x 17.1 inches wide x 3.4 inches high |
The following image is of the QRadar Network Insights 1920-C appliance.
Picture: © 2018 Dell Inc. or its subsidiaries. All Rights Reserved
| Label | Description |
|---|---|
| 1 | QRadar firmware storage |
| 2 | 1 x RJ-45 10/100/1000 Mb Ethernet systems management (IMM) port |
| 3 | Management ports (10 GbE SFP+) |
| 4 | Management ports (1 GbE TX) |
| 5 | Network Packet Capture (SFP/SFP+) Ports are numbered 3, 2, 1, 0, from left to right. |
| 6 | Do not use these ports |
For information about battery replacement, see Dell EMC PowerEdge R740 Installation and Service Manual (https://topics-cdn.dell.com/pdf/poweredge-r740_owners-manual_en-us.pdf).