Installing an adapter in the 5105-22E,
9008-22L, 9009-22A, 9009-22G,
9223-22H, or 9223-22S
system
To install an adapter in the system, complete the steps in this
procedure.
Procedure
Ensure that you have the electrostatic discharge (ESD) wrist strap on
and that the ESD clip is plugged into a ground jack or connected to an unpainted metal surface. If
not, do so now.
Ensure that the target slot is empty.
If necessary, remove the adapter from the antistatic package.
Attention: Avoid touching the components and gold connectors on the
adapter.
Place the adapter, component-side up, on a flat, antistatic
surface.
Attention: A pin on the tailstock of the adapter resembles a
removable screw. Do not remove this pin. It is required for correct alignment and seating.
If the adapter latch
(B) at the target slot on the system is not already in the open position,
pull the latch into the open position by rotating the latch outwards from its clip on the back of
the system.
See Figure 1 for the location of the adapter
latch.
(L007)
CAUTION:
A hot surface nearby. (L007)
Attention: Before you insert the adapter in the slot,
ensure that the adapter has nothing attached to it.
Press the adapter firmly into
its connector ensuring that it is seated.