Configuring the HMC so that it can connect to service and support by using the call-home setup wizard

Configure the HMC so that it is a call-home server by using the call-home wizard.

Before you begin

This procedure describes how to configure the HMC as a call-home server by using direct (LAN-based) and indirect (SSL) connections to the internet.
Before you begin this task, ensure that:
  • The network administrator verifies that connectivity is allowed. For more information, see Preparing for HMC configuration.
  • If you are configuring internet support through a proxy server, you must also have the following information:
    • The IP address and port of the proxy server
    • The proxy authentication information
  • The adapter that is designated as eth1 (the one that is designated as an open network) is used. For more information, see Choosing network settings on the HMC.
  • An Ethernet cable physically connects the HMC to the LAN.

To configure the HMC so that it is a call-home server by using the call-home wizard, complete the following steps:

Procedure

  1. In the navigation area, click the Serviceability icon Serviceability icon, and then select Service Management.
  2. In the content pane, click Call-Home Setup Wizard. The Connectivity and Call-Home Servers wizard opens. Follow the instructions in the wizard to configure call-home.