Completing an ESLL or ESLS storage enclosure installation

To complete the installation process, complete the steps in this procedure.

1. If you installed disk drives or SSDs into your enclosure, configure the drives for use by your operating system, by referring to the following information:
   • To configure a disk drive or SSD for use by AIX®, see Configuring a disk drive or solid-state drive for use in an AIX system or AIX logical partition.
   • To configure a disk drive or SSD for use by IBM® i, see Configuring a disk drive or solid-state drive for use in an IBM i system or IBM i logical partition.
   • To configure a disk drive or SSD for use by Linux®, see Configuring a disk drive or solid-state drive for use in an Linux system or Linux logical partition.
2. To verify that the system or logical partition recognizes the disk drive enclosure, see Verifying the installed part.
3. You have completed the steps to install an ESLL or ESLS storage enclosure.
   If you were directed here from another procedure, return to that procedure now.