UJE38
Too many jobs are running that use the communications controller.
Before you can run your communications job, you must perform one or more of the following actions:
- End any diagnostic program that might be running, such as the Communications Trace Program.
- Vary off a line that is using the controller.
- Lower the speed of a line that uses the controller.
Complete the following steps to determine which lines are using the controller:
- Vary off the failing line using the VRYCFG command.
- Vary the line on again, with the reset option of the VRYCFG command set to Yes. The names of the lines using the controller will be displayed.
This ends the procedure.
