UJC37

A configuration problem occurred.

Verify that the configuration parameters for your asynchronous equipment are correct by performing the following actions:

• Display the line description with the DSPLIND command (created by the CRTLINASC command).
• Display the controller description with the DSPCTLD command (created by the CRTCTLASC command).
• Display the remote device description with the DSPDEVD command (created by the CRTDEVASC command).

Some software problems can be temporarily solved by changing the configuration parameter, even if the original value was correct.

Report this problem to your service representative if you use this temporary change.

This ends the procedure.