UJA33
The problem can be caused by too many active lines using the same input/output processor (IOP) or by setting the line speed too high.
Complete the following to find which active lines use the same IOP, and to correct the problem:
- Vary off the failing line using the VRYCFG command.
- Vary the line on again, with the reset option of the VRYCFG command set to Yes. The active lines that use the IOP will be displayed with their line speeds.
- Determine whether there are too many lines using the IOP, or whether the line speeds are too high.
- Correct the configuration as needed.
This ends the procedure.