Reference tables for IPL types, system operating modes, and speeds.
Table 1, Table 2, Table 3, and Table 4 describe the valid IPL types, system operating modes, speeds, and firmware IPL modes that are used in control panel functions 01 and 02. Table 5 describes whether the Hardware Management Console (HMC) is active for HMC managed systems.
IPL type | Action or description |
---|---|
A | IPL from disk using copy A of the system Licensed Internal Code. |
B | IPL from disk using copy B of the system Licensed Internal Code. |
C | Reserved for hardware
service use only under the direction of Rochester development support. Attention: Severe data loss can occur with improper use of this function.
|
D | IPL from media other than load-source disk. Alternate IPL for code installation support. |
System operating mode | Action or description |
---|---|
Manual (M) | Allows you to access DST and perform an attended IPL. |
Normal (N) | Allows you to access the operating system and perform an unattended IPL. |
IPL speed | Action or description | Details |
---|---|---|
F | Fast override for one IPL. | Fast IPL run. Some hardware diagnostics are skipped. |
S | Slow override for one IPL. | Full hardware diagnostics run. Use whenever
hardware is changed, for intermittent hardware failure, and on the first installation
IPL. The following diagnostics are run:
|
V=F | Use system-defined speed. | Fast IPL set by system value (displayed at function 01). |
V=S | Use system-defined speed. | Slow IPL set by system value (displayed at function 01). |
V | Fast IPL or slow IPL set by the system value (selected at function 02). | Function 02 selection or the system default at each IPL. |